When you find a stain in your sex doll, it is necessary to remove it as soon as possible. Because TPE is porous, the stain will absorb deeper and deeper into the material over time; the faster you perform the treatment, the better.
If it is not a serious stain, we always recommend leaving it untreated. A stain that has gotten into a TPE sex doll will eventually fade and disappear on its own over time (weeks or months).
How do stains occur in a sex doll?
Stains in your sex doll can be caused by dyes from ink, paint, makeup, clothing, or other materials. This happens because TPE sex dolls are porous, causing other liquids to absorb into the material.
For silicone sex dolls, the risk of stains is much lower because silicone is a far less porous material.
Usually, stains will eventually fade from a TPE sex doll on their own, but this can take weeks or months. If you want to get rid of the stains as quickly as possible, you can use our instructions.
Disclaimer: Perform this cleaning at your own risk; treating, adjusting, or modifying your sex doll always carries risks and does not guarantee a good result.
What should you especially avoid doing when dealing with stains in a sex doll?
If you try to remove stains using the wrong products, you can permanently damage the doll. In any case, avoid the following:
- No harsh solvents: Never use acetone, nail polish remover, pure alcohol, white spirit (mineral spirits), or turpentine. This eats directly into the material and irrevocably ruins the doll's skin.
- No scrubbing: Do not use scouring pads, hard brushes, or abrasive cleaners. This causes permanent scratches and damages the structure.
- Do not pull or stretch too hard: Do not rub or pull wildly to 'remove' the stain, as this can deform or tear the doll. Be gentle and always use a soft, dabbing washing method.
- No makeup remover with oils or perfume: This can affect the chemical composition of TPE, causing the material to remain permanently sticky or ruined.
Instructions for removing stains from a sex doll
First, clean the doll with mild soap or a toy cleaner. The stain might already disappear with a simple cleaning session. If this is not enough, you can follow the steps below.
Gather the following materials:
- Acne cream with benzoylperoxide (preferably a strength of 5% to 10%)
- Mild, unfragranced soap and lukewarm water
- Plastic wrap (cling film)
- Cotton swabs or a clean microfiber cloth
- Talcum powder and a soft brush
- Preparation and cleaning
Wash the stain and the immediate surrounding area thoroughly with lukewarm water and mild soap to remove dirt and skin oils. Afterwards, pat the area dry with a clean towel.
- Applying the acne cream
Apply a thick layer of acne cream directly onto the stain. Make sure the stain is completely covered.
Warning: Be very careful with painted parts, such as lips, nipples, or eyebrows. The benzoylperoxide will not only bleach the stain but also strip the paint off the doll.
- Covering up
Cover the cream-covered stain airtight with a piece of plastic wrap. The cream only works as long as it stays wet; if the cream dries out, its action stops immediately. The wrap prevents drying out.
- Allowing it to set
Leave the cream on for 12 to 24 hours.
Tip: Sometimes it helps to place the doll in a bright spot (indirect sunlight or near a lamp), as light and heat accelerate the chemical reaction. Check after a few hours to ensure the material is reacting well.
- Rinsing and checking
Remove the plastic wrap after the processing time. Wipe away the remaining cream with a damp cloth and wash the area thoroughly with lukewarm water and mild soap.
Is the stain not completely gone yet? You can repeat the treatment if necessary with a new layer of cream and fresh wrap. Repeat this 3 to 5 times if needed.
- Post-treatment (Powdering)
Because TPE can sometimes feel a bit sticky or stiff after intensive cleaning, it is important to rub a thin layer of talcum powder onto the treated area after it dries. Brush away the excess powder with a soft brush.
Tip: If the skin feels dry, you can make it softer and more moisturized again by applying some mineral oil or baby oil to the skin. Do this in small amounts until the skin feels normal again.
Can silicone sex dolls also get stained?
Yes, but to a much lesser extent. Silicone is a lot more compact and less porous than TPE (Thermoplastic Elastomer). Because of this, stains do not absorb as deeply or quickly into the material. However, silicone dolls are not one hundred percent stain-proof.
- Strong dyes (such as printer ink or intense clothing dye that rubs against it for a long time) can definitely adhere to silicone.
- The big advantage is that silicone is more resistant to cleaning and less prone to permanent discoloration than TPE.
How do I prevent stains in a sex doll?
Prevention is much easier than a cure when it comes to sex dolls. You can minimize stains in the following ways:
- Pre-wash new clothing: Dark clothing, especially jeans, easily releases dye. Always wash new outfits 3 to 5 times before dressing the doll in them.
- Use an undergarment: Put a light, inexpensive, tight undergarment or bodysuit on the doll as a barrier between the skin and colored clothing.
- Beware of furniture and leather: Never let the doll sit directly on a faux-leather couch, painted chair, or wooden surface for extended periods. The dyes or oils from the furniture can irrevocably bleed into the doll.
- No newspapers or magazines: Never lay the doll on printed paper goods; the printing ink transfers directly onto the material.
- Use light-colored clothing: Choose white, light pink, or skin-toned clothing. These must also be pre-washed 3 to 5 times to minimize color transfer.
- Limit clothing time: Minimize the time the doll wears clothing; make sure to remove the clothing after use and leave the sex doll naked for as long as possible.
